HX series of anaerobic adhesives covers a wide range of industrial applications. These single component materials are available in varying strengths, types, viscosity's and color-coding. From permanent fixture to lower strength grades that can be disassembled using ordinary tools. From very fast custom manufacture to suit customer requirements.

Anaerobic adhesives cure by the catalytic effect of metal and absence of air. When both conditions are met these adhesives/sealants form a tough, low shrinkage polymer providing total contact between two interfaces resulting in a vibration and leak-proof assembly. Anaerobic are kept in their liquid state by the use of special stabilizers and atmospheric oxygen.
Anaerobic can be affected by the following

    Dirty surfaces .
    Greasy surfaces .
    Inactive surfaces i. e. stainless steel .
    Large gap filling .
    Prolonged high temperature

Correct cleaning can overcome dirty and greasy surfaces by the use of a degreasing agent. Inactive surfaces can mean that the adhesives take a longer time to cure or use a surface activator. For Gap filling checks that you are using the correct grade. Better results can be obtained with a surface activator.

Prolonged high temperatures above 150 °C can affect overall performance. Over 170 °C materials start to degrade fast. Certain grades will allow higher temperature performance. Most grades will retain full strength on cooling providing maximum service temperature has not been exceeded.

In liquid form, HX anaerobic can be removed with most organic solvents such as acetone, Hardened HX anaerobic show good resistance to most organic solvents, hydrocarbons, oils and gases.

One part adhesive .
Solvent free .
Nonflammable .
Low toxicity .
Low odor .
Cost effective, elimination of locking washers, split pins, etc.
Repairs can be made to worn components such as bearing housings.
Tolerances can be reduced .
Prevents loosening due to vibration .
Seals porous surfaces .
Prevents corrosion .